Agilent Technologies 6850 Series Service Information page 218

7. Disconnect the sensor cable from the main
board.
Released: April 2004
8. Remove the three screws (T-20 Torx) secur-
9. Feed the sensor cable up through the hole in
10. Remove the oven heater shroud. Feed the
Oven sensor cable
6850 Series Gas Chromatograph Service Procedures
ing the oven heater shroud in the oven.
the bottom of the oven, and remove the extra
insulation and save it.
oven heater wires out through the hole in the
back of the oven. These same wires will be
used to install the new oven shroud. Remove
any extra insulation from the wires and save
it.
219