Agilent Technologies 6850 Series Service Information page 18

1. Open the lid.
2. Loosen the screw on the side of the counter-
balance cam that secures the stop plate. The
stop plate will drop down. Raise the cover to
the full upright service position. See the
figure below.
Released: April 2004
3. When servicing is complete, move the lid to
Electronics cover
To remove the electronics cover:
1. Open the lid.
Stop plate
2. Raise the lid to the service position. See
Screw
6850 Series Gas Chromatograph Service Procedures
the normal open position and slide the stop
plate all the way up into position behind the
roller. Tighten the stop plate screw.
WARNING
Shock hazard. Before beginning, turn off the
instrument and disconnect the power cord.
"Raising the lid to the service position"
page 1-17 for details.
on
18