Agilent Technologies 6850 Series Service Information page 80

NOTE: If desired, you can remove the entire inlet
for better access.
Heater/Sensor
assembly
Figure 1-22. Removing the heater/sensor
assembly from the top of the
GC
Released: April 2004
2. Remove the two Torx T-20 screws securing
3. Lift the heater/sensor leads out of the weld-
Cooling fin
4. Install the new heater/sensor assembly and
Leak testing EPC and manual inlets
Preparation
1. Cool the column to ambient.
2. Remove the column from the inlet fitting on
6850 Series Gas Chromatograph Service Procedures
the cooling fin to the inlet weldment and
remove the fin.
ment channel and lift the assembly out of the
inlet.
reassemble the inlet. You may need to use
tweezers to seat the cable back in the chan-
nel and fully seat the heater/sensor in the
weldment.
the inside of the oven.
80