Agilent Technologies 6850 Series Service Information page 182

Ignitor
Figure 1-20. Removing the FPD housing from
the support bracket.
7. Use two wrenches to loosen the Swagelok
connection between the jet assembly and the
heated transfer tube.
Released: April 2004
new?
Vent line
Loosen screws
(one screw hidden)
6850 Series Gas Chromatograph Service Procedures
Heater transfer line nut
U-clamp screws
8. Carefully lift the detector module and jet
assembly off of the transfer tube and out of
the GC. Be careful not to damage the fused
silica gigabore liner.
Ignitor cable
Jet assembly
Heater block
182