Agilent Technologies 6850 Series Service Information page 215

8. Unscrew the two T-10 Torx screws that hold
the flap motor onto the duct.
Motor mounting
screws
Flap cable
mounting screw
Flap cable
Released: April 2004
To install the oven flap and motor
1. Hold the flap motor with the cable to the
2. Install the flap motor onto the duct using
6850 Series Gas Chromatograph Service Procedures
left, rotate the collar so the flat side is
parallel with the side of the motor, and insert
the motor into the assembly.
Collar
Flap cable (to inside)
two T-10 Torx screws.
216