Confirmation After Operation; When Multiple Conveyers Are Used - Mitsubishi Electric CR800 Series Instruction Manual

8 Calibration of Conveyer and Robot Coordinate Systems ("A1" program)
(13) Press [F1] (FWD) key and execute step feed "(8) Perform step operation..." is displayed.
Perform step operation until "End."
* The amount of robot movement per encoder pulse is calculated based on this operation.

Confirmation after operation

8.3.
Check the value of "P_EncDlt" using T/B.
* This value indicates the movement of each coordinate (mm) of the robot coordinate system,
corresponding to the movement of the conveyer per pulse.
Example) If "0.5" is displayed for the Y coordinate only
This means that if the conveyer moves for 100 pulses, the workpiece moves 50 mm (0.5 x 100 = 50)
in the +Y direction in the robot coordinate system.
When backing up, the data of "P_EncDlt" is not backed up.
Please work referring to "16.6 Restore backup data to another controller" when you restore data to another
tracking system.

When multiple conveyers are used

8.4.
Carry out the same operations as above when multiple conveyers are used as well, but pay attention to the
following points.
Example) When using conveyer 2 (encoder number "2"),
(a) Copy the "A1" program, please create a "A2" program.
(b) Please change the encoder number for variable "MEncNo" in the "A2" program to "2".
8-56 Confirmation after operation