Wireless Modulation Technologies - Cisco 8961 Administration Manual

Wireless Modulation Technologies

Standard
802.11b
1 Adjusts dynamically when associating with an AP if the AP client setting is enabled.
Note
2 Advertised rates by the APs are used. If the Restricted Data Rates functionality is enabled in the Cisco
Unified Communications Manager Administration phone configuration, then the Traffic Stream Rate
Set IE (CCX V4) is used.
For more information about supported data rates, Tx power and Rx sensitivity for WLANs, see the Cisco
Unified IP Phone 9971 Wireless LAN Deployment Guide at this location:
http://www.cisco.com/en/US/products/ps10453/products_implementation_design_guides_list.html
Wireless Modulation Technologies
Wireless communications use the following modulation technologies for signaling:
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
88
REVIEW DRAFT - CISCO CONFIDENTIAL
Maximum Tx power
(See Note 1)
16 dBm
17 dBm
Data rate (See Range
Note 2)
6 Mbps 709 ft (216 m)
9 Mbps 650 ft (198 m)
12 Mbps 623 ft (190 m)
18 Mbps 623 ft (190 m)
24 Mbps 623 ft (190 m)
36 Mbps 495 ft (151 m)
48 Mbps 413 ft (126 m)
54 Mbps 394 ft (120 m)
1 Mbps 1,010 ft (308 m)
2 Mbps 951 ft (290 m)
5.5 Mbps 919 ft (280 m)
11 Mbps 902 ft (275 m)
VoIP Wireless Network
Receiver sensitivity
-91 dBm
-90 dBm
-87 dBm
-86 dBm
-82 dBm
-80 dBm
-77 dBm
-76 dBm
-96 dBm
-85 dBm
-90 dBm
-87 dBm