Mlpp Authorization Setup For End User - Cisco 8961 Administration Manual

Features, Templates, Services, and User Setup
When the check box is enabled, the system challenges the Cisco or third-party AS-SIP phone for the user's
credentials when a precedence call is initiated from the device.

MLPP Authorization Setup for End User

Configure MLPP Authorization for a user on the End User administration page.
The MLPP User Identification number must be composed of 6 – 20 numeric characters.
The MLPP Password must be composed of 4 – 20 numeric (0-9) characters
The Precedence Authorization level can be set to any standard precedence level from Routine to Executive
Override
MLPP DSCP Setup for End User
The DSCP values for video streams can be configured for each precedence level in the QOS section of the
Service Parameters. All DSCP values include the decimal value in the setting.
Enable Video On/Off Setting
The Enable Video On/Off setting improves the video conference call flow by removing the black box that is
displayed when one party has the Auto Transmit setting on their phone set to Off.
This setting works in conjunction with Auto Transmit. If the Enable Video feature is set to Off, it overrides
the Auto Transmit setting and you can send audio calls. But if Enable Video is set to On and Auto Transmit
is set to Off, the video stream is blocked and the user sends a black box to the other party. For this feature to
function, Cisco recommends Auto Transmit remains On.
The Enable Video On/Off setting functions like Video Capability: Enable/Disable on Cisco Unified
Communications Manager (Unified CM). However, the server settings override the phone settings so if video
is disabled on the Unified CM, this feature is not available on the phone and all calls are audio only.
Dial Tone from Release Button Setup
You can provide users with one-button access to the dial tone and the New Call window from an active call.
You enable this option from one of the following Cisco Unified Communications Manager windows:
• System > Enterprise Phone Configuration
• Device > Device Settings > Common Phone Profile
• Device > Phone > Phone Configuration
The following table describes the field for the Dial Tone from Release button feature.
REVIEW DRAFT - CISCO CONFIDENTIAL
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
Enable Video On/Off Setting
(SIP)
193