Perform Camera Postinstallation Checks; Cisco Unified Video Camera Information - Cisco 8961 Administration Manual

Perform Camera Postinstallation Checks

resume video transmission in this case, press the Unmute Video softkey
on or off, follow these steps:
Procedure
Step 1
On the Cisco Unified IP Phone, press Applications
Step 2 Select Accessories.
Step 3
Highlight Cisco Unified Camera.
Step 4 Press Setup.
Step 5 Move the Auto Transmit slider bar to On or Off.
Perform Camera Postinstallation Checks
After installing the Cisco Unified Video Camera, perform the following checks:
1 Wait until the camera ready message appears.
The camera may need to upgrade after installation. It may take a few minutes before the camera is
Note
operational.
2 Press Video Preview to check the picture quality.
3 Move the phone and camera to a position where no bright lights are in the field of view.
4 Move the phone and camera so that the user is illuminated by light that comes from the front.

Cisco Unified Video Camera Information

For information about placing and receiving video calls, setting up video conferences, and adjusting camera
settings on the phone, see the Cisco Unified Video Camera Quick Start Guide at this location:
http://www.cisco.com/en/US/products/ps10655/products_user_guide_list.html
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
82
REVIEW DRAFT - CISCO CONFIDENTIAL
• If the video preview image looks too blue, try increasing the camera Brightness setting.
• If the background looks washed out, try decreasing the camera Brightness setting.
For information about adjusting camera settings on the phone, see the Cisco Unified
Note
Video Camera Quick Start Guide at this location:
http://www.cisco.com/en/US/products/ps10655/products_user_guide_list.html
Cisco Unified Video Camera setup
. To turn the Auto Transmit setting
.