Cisco 8961 Administration Manual page 352

Cisco Unified IP Phone Non-Lockable Wall Mount
Install Non-Lockable Wall Mount Kit for Phone
REVIEW DRAFT - CISCO CONFIDENTIAL
Install Non-Lockable Wall Mount Kit for Phone
The wall mount kit can be mounted on most surfaces, including concrete, brick, and similar hard surfaces.
To mount the kit on concrete, brick, or similar hard surfaces, you must provide the appropriate screws and
anchors for your wall surface.
Procedure
Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
Note If the jack is to be placed behind the phone, the Ethernet jack must be flush to the wall or recessed.
a) Hold the bracket on the wall, placing it so that the arrow on the back of the bracket is pointing up.
b) Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.
c) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor
into the wall.
d) Screw the anchor clockwise into the wall until it is seated flush.
e) Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
328