Cisco 8961 Administration Manual page 338

Before You Begin
• Two #4-40x1/4-inch machine screws
• One 6-inch Ethernet cable
• One key if the bracket includes the optional lock
Before You Begin
You need these tools to install the bracket:
• #1 and #2 Phillips-head screwdrivers
• Level
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not
currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular
telephone jack. For more information about phone installation requirements and warnings, see
IP Phone Installation, on page
Install Bracket
To install the phone on the wall:
Procedure
Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
a) Use the level to ensure that the bracket is level, then use a pencil to mark the screw holes.
b) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor
into the wall.
c) Screw the anchor clockwise into the wall until it is seated flush.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
314
REVIEW DRAFT - CISCO CONFIDENTIAL
55.
Cisco Unified IP Phone Wall Mount
Cisco Unified