Cisco 8961 Administration Manual page 332

Cisco Unified Communications Manager User Addition
Cisco Unified Communications Manager User Addition
This section provides steps for adding a user to Cisco Unified Communications Manager. Follow one of the
procedures in this section, depending on your operating system and the manner in which you are adding the
user.
Add User from External LDAP Directory
If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you can
immediately synchronize that directory to the Cisco Unified Communications Manager on which you are
adding this same user and the user phone by following these steps:
Procedure
Step 1 Sign into Cisco Unified Communications Manager Administration.
Step 2
Choose System > LDAP > LDAP Directory.
Step 3 Use Find to locate your LDAP directory.
Step 4 Click on the LDAP directory name.
Step 5 Click Perform Full Sync Now.
Note
Step 6 Proceed to
Add User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly with Cisco Unified Communications
Manager Administration by following these steps:
If LDAP is synchronized, you cannot add a user with Cisco Unified Communications Manager
Note
Administration.
Procedure
Step 1 Choose User Management > End User, then click Add New. The End User Configuration window appears.
Step 2 In the User Information pane of this window, enter the following:
• User ID: Enter the end user identification name. Cisco Unified Communications Manager does not
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
308
REVIEW DRAFT - CISCO CONFIDENTIAL
If you do not need to synchronize the LDAP Directory to the Cisco Unified Communications Manager
immediately, the LDAP Directory Synchronization Schedule on the LDAP Directory window
determines when the next autosynchronization is scheduled. However, the synchronization must
occur before you can associate a new user to a device.
Phone Setup, on page
permit modifying the user ID after it is created. You may use the following special characters: =, +, <,
>, #, ;, \, , "", and blank spaces. Example: johndoe
309.
Basic Phone Administration Steps