Position Display Functions - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Basic operation | Position display
Symbol
6.9.2

Position display functions

Setting the spindle speed
You can control the spindle speed depending on the configuration of the
connected machine tool.
If no entry is made in the spindle speed input field for three seconds,
the device switches back to the display of the current spindle speed.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Meaning
Spindle speed cannot be achieved with selected gear stage
Select a higher gear stage
Spindle speed cannot be achieved with selected gear stage
Select a lower gear stage
In MDI mode and Program Run , a scaling factor is applied
to the axis
Further information:
access menu", Page 81
Axis is feedback-controlled
Actual spindle speed
Input field for controlling the spindle speed
Further information:
Page 79
To switch from the display of the spindle speed to the input
field (if required), drag the display to the right.
The Spindle speed input field is displayed
Tap or long-press + or – to set the spindle speed to the
desired value
or
Tap the Spindle speed input field
Enter the desired value
Confirm entry with RET
The product applies the entered spindle speed as the
nominal value and controls the spindle of the machine tool
accordingly
To return to the display of the spindle speed, drag the input
field to the left
"Adjusting settings in the quick
"Setting the spindle speed",
6
79