Simulation Window - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | General
Parameter
Digits before the decimal point
for size-adjusted axis display

Simulation window

Simulation window
15.2.4
Settings ► General ► Display ► Simulation window
Path:
Parameter
Line thickness of tool position
Color of tool position
Line thickness of current
contour element
Color of current contour
element
Tool path
Horizontal alignment
Vertical alignment
The Undo buttons enable the color definitions of the simulation window
to be reset to factory settings.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Explanation
The number of digits in front of the decimal point indicates the
size at which the position values are displayed. If the number of
digits in front of the decimal point is exceeded, then the display
is reduced in size so that all of the digits can be shown.
Setting range: 0 ... 6
Default value: 3
Configuration of the simulation window for MDI mode and
program run.
Further information: "Simulation window", Page 231
Explanation
Line thickness for displaying the tool position
Settings: Standard or Bold
Default value: Standard
Definition of the color for displaying the tool position
Setting range: Color scale
Default setting: Orange
Line thickness for displaying the current contour element
Settings: Standard or Bold
Default value: Standard
Definition of the color for displaying the current contour element
Setting range: Color scale
Default setting: Green
Use of the tool path
Settings: ON or OFF
Default value: ON
Horizontal orientation of the coordinate system in the simulation
window
Settings:
Rightward: values increase to the right
Leftward: values increase to the left
Default value: Rightward
Vertical orientation of the coordinate system in the simulation
window
Settings:
Upward: values increase in the upward direction
Downward: values increase in the downward direction
Default value: Upward
15
231