Checking A Program In The Simulation Window; Managing Programs; Opening A Program; Closing A Program - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Programming | Using the simulation window
13.4.3

Checking a program in the simulation window

13.5

Managing programs

After you have created a program, you can save it for automatic program run or
subsequent editing.
The default storage location for programs is Internal/Programs.
13.5.1

Opening a program

13.5.2

Closing a program

13.5.3

Saving a program

HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Tap Graphic
The simulation window for the current program appears
Tap each program block, one after the other
The program steps are displayed in the simulation window;
you can enlarge the detail view as needed
To enlarge the view, tap Detail view
To return to the overview view, tap Overview
Tap Open program in the program management
Select the storage location in the dialog, e. g.
Internal/Programs or USB mass storage device
Tap the folder containing the file
Tap the file
Tap Open
The selected program is loaded
Tap Close program in the program management
The opened program is closed
Tap Save program in the program management
The program is saved
13
217