Programming A Bolt Hole Circle And Row Of Holes (Programming); Creating The Program Header; Figure 37: Example Workpiece - Programming A Bolt Hole Pattern And A Row Of Holes - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Quick Start | Determining the preset (manual operation mode)
Activating the preset
9.9 Programming a bolt hole circle and row of holes
(programming)
Machine the bolt hole circle and row of holes in Programming mode of operation.
You may be able to reuse the program in a small batch production. The values
to be entered into the input fields can be taken directly from the dimensioned
production drawing.
Figure 37: Example workpiece – programming a bolt hole pattern and a row of holes
Calling up
9.9.1

Creating the program header

HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Tap Presets on the status bar
The Presets dialog opens
Tap preset 1
Tap Confirm
The preset is set
On the status bar, is displayed for the preset
1
Tap Programming in the main menu
The user interface for programming is displayed
Tap Create new program in the program management
A dialog box is opened.
In the dialog select the storage location, e.g.
Internal/Programs in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Create
A new program containing the Program header start block is
created
In Name enter the name Example
Confirm the entry with RET
In Unit for linear values select the mm unit of measure
The program has been successfully created; you can then
begin with programming
9
163