Block Types; Positioning; Coordinate Systems - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Programming | Block types
13.2

Block types

You can use the following block types for programming:
Positioning functions
Change of coordinate system (preset)
Machine functions
Machining pattern
13.2.1

Positioning

You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
You can load the current axis position with Actual position capture into
the appropriate input fields.
The following parameters are available:
Positioning block
Parameter
R0
R+
R–
13.2.2

Coordinate systems

To change a coordinate system, you can call presets from the preset table. The
coordinate system of the selected preset will then be used after the call.
Further information:
Preset block
Parameter
Preset number
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Description
Tool radius compensation disabled (default setting)
Positive tool radius compensation; the traverse path is
increased by the tool radius (outside contour)
Negative tool radius compensation; the traverse path is
decreased by the tool radius (inside contour)
Incremental position value, i.e. the position value is
referenced to the actual position
Through-hole drilling without a specified position value
(only for a manually operated Z axis)
"Defining presets", Page 172
Description
ID from the preset table
Optional: Selection from preset table
13
207