Block Types; Positioning; Machining Pattern - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

11
11.2

Block types

You can use the following block types for machining in the MDI mode:
Positioning functions

Machining pattern

11.2.1

Positioning

You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
The following parameters are available:
Positioning block
Parameter
R0
R+
R–
11.2.2 Machining pattern
You can define various machining patterns to machine complex shapes. From the
data you enter, the product calculates the geometry of the machining patterns and
optionally displays them in the simulation window.
186
You can load the current axis position with Actual position capture into
the appropriate input fields.
Description
Tool radius compensation disabled (default setting)
Positive tool radius compensation; the traverse path is
increased by the tool radius (outside contour)
Negative tool radius compensation; the traverse path is
decreased by the tool radius (inside contour)
Incremental position value, i.e. the position value is
referenced to the actual position
Through-hole drilling without a specified position value
(only for a manually operated Z axis)
Before defining a machining pattern, you must
Define a suitable tool in the tool table
Select the tool on the status bar
Further information: "Creating a tool table", Page 143
You can load the current axis position with Actual position capture into
the appropriate input fields.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
MDI mode | Block types