Mounting On Duo-Pos Stand; Figure 4: Product Mounted On Duo-Pos Stand; Figure 5: Cable Routing On Duo-Pos Stand - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

4
4.2.2

Mounting on Duo-Pos stand

You can fasten the Duo-Pos stand to the product at a 20° or 45° angle.
Use the provided M4 x 8 ISO 7380 hexagon socket screws to fasten the stand
to the lower VESA 100 threaded holes on the rear panel
Using the mounting slots (width = 4.5 mm), screw the stand to a supporting
surface
or
Set up the device freely at the desired location
Route the cable from behind through the two supports of the stand and then
through the lateral openings to the connections
Figure 4: Product mounted on Duo-Pos
stand
Further information:
42
Comply with the permissible tightening torque of 2.6 Nm
"Product dimensions with Duo-Pos stand", Page 306
Mounting | Assembly of the product

Figure 5: Cable routing on Duo-Pos stand

HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020