Overview - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

11
11.1

Overview

This chapter describes the Manual Data Input (MDI) operating mode and how to
execute machining steps in single blocks in this mode.
Short description
MDI mode allows you to execute one machining block at a time. The values to
be entered can be applied directly in the input field from a properly dimensioned
production drawing.
The functions provided by MDI mode enable efficient single-part production. For
small-batch production, you can program the machining steps in Programming
mode and then execute them in Program run mode.
Further information:
Further information:
Calling up
184
Make sure that you have read and understood the "Basic operation"
chapter before carrying out the actions described below.
"Basic operation", Page 57
Further information:
Before you can use the product in the MDI mode, the presets must be
set in the Manual Operation mode.
Further information: "Defining presets", Page 172
"Programming ", Page 205
"Program run ", Page 197
Tap MDI in the main menu
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
MDI mode | Overview