Adjusting Settings In The Quick Access Menu - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Basic operation | Status bar
Operating
element
6.10.2

Adjusting settings in the quick access menu

With the quick access menu, you can adjust the following settings:
The availability of settings in the quick access menu depends on the
which user is logged in.
Unit for linear values (Millimeters or Inch)
Unit for angular values (Radian, Decimal degrees or Deg-Min-Sec)
The Scaling factor by which the stored position is multiplied during execution
of an MDI block or program block
Feed-rate value for axes in the Manual operation and MDI operating modes
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Function
Tool table
Display of the current tool; tapping opens the tool table
"Creating a tool table", Page 143
Further information:
Stopwatch
Time display with Start / Stop function in h:mm:ss format
Further information: "Stopwatch", Page 82
Calculator
Calculator with the most important mathematical functions
and speed calculator
"Calculator", Page 83
Further information:
Feed rate
Display of the current feed rate of the fastest linear axis
If all linear axes are at a standstill, the feed rate of the
fastest rotational axis is shown
The feed-rate value can be set in the Manual operation and
MDI operating modes; tapping it opens the feed-rate menu
Override
Display of the changed traversing speed of the fastest
linear axis.
If all linear axes are at a standstill, the changed traversing
speed of the fastest rotational axis is displayed
The change is made using an external controller on an NC-
controlled machine tool
Auxiliary functions
Auxiliary functions in Manual operation mode
Further information: "Additional functions in Manual
operation mode", Page 83
MDI block
For creating machining blocks in MDI mode
6
81