Running The Program - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

12
12.2.1

Running the program

With NC-controlled axes and software option POSITIP 8000 NC1
With manual machine tools
In Single block mode
200
If the program does not contain a Feed rate block, the product uses the
maximum machine speeds that are given in the menu.
"Special settings", Page 249
Further information:
Press the NC START key on the machine tool
The product selects the first block of the program
Press the NC START key on the machine tool again
User intervention may be required, depending on the block.
The wizard shows the appropriate instruction
With a tool call for example, the spindle is automatically
stopped and you are requested to change the corresponding
tool
With multi-step blocks, such as machining patterns, tap Next
to proceed to the next step in the wizard
Follow the wizard's instructions for the block
Blocks that do not require any action by the user
(such as presetting) are executed automatically.
Press the NC START key to execute the next block, and
continue in this manner until the end of the program
Tap NC START on the program control
The product selects the first block of the program
Tap NC START on the program control once again
User intervention may be required, depending on the block.
The wizard shows the appropriate instruction
With a tool call for example, the spindle is automatically
stopped and you are requested to change the corresponding
tool
With multi-step blocks, such as machining patterns, tap Next
to proceed to the next step in the wizard
Follow the wizard's instructions for the block
Blocks that do not require any action by the user
(such as presetting) are executed automatically.
Tap NC START to execute the next block, and continue in this
manner until the end of the program
Tap Single block on the program control to activate Single
Block mode
When the Single Block mode is active, the program stops
after each block of the program control (this also includes
blocks that do not require any action by the user)
Program run | Using the program
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020