HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 155

Quick Start | Requirements
Tools
The following tools are available:
Drill Ø 5.0 mm
Drill Ø 6.1 mm
Drill Ø 19.8 mm
Reamer Ø 20 mm H6
End mill Ø 12 mm
Countersink Ø 25 mm 90°
M6 tap
Tool table
For the example it is presumed that the tools for machining are not yet defined.
For each tool used, you must therefore define the specific parameters in the tool
table of the product. During subsequent machining you can access the parameters
in the tool table via the status bar.
Further information:
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
"Creating a tool table", Page 143
Tap Tools on the status bar
The Tools dialog box appears
Tap Open table
The Tool table dialog box appears
Tap Add
In the Tool type input field, enter the name Drill 5.0
Confirm the entry with RET
In the Diameter input field, enter the value 5.0
Confirm the entry with RET
In the Length input field, enter the length of the drill
Confirm the entry with RET
The defined Ø 5.0 mm drill is added to the tool table
Repeat this procedure for the other tools, and use the
naming convention [Type] [Diameter]
Tap Close
The Tool table dialog box is closed
9
155