Axes; Fundamentals Of Axis Configuration; Figure 62: Assignment Of The Rectangular Coordinate System To The Machine Axes - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Axes

Axes

15.5
This chapter describes settings for configuring the axes and assigned devices.
Not all of the described parameters and options may be available,
depending on the product version, configuration and the connected
encoders.
15.5.1

Fundamentals of axis configuration

In order to use functions such as the execution of blocks, the
configuration of the axes must comply with the requirements of the
respective application.
Reference system on milling machines
When machining a workpiece on a milling machine, the right-hand rule helps you
to remember the three axis directions: the middle finger points in the positive
direction of the tool axis from the workpiece toward the tool (the Z axis), the
thumb points in the positive X direction, and the index finger in the positive Y
direction.

Figure 62: Assignment of the rectangular coordinate system to the machine axes

HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
15
243