Example 3: Setting A Preset On A Circle Center - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Manual operation | Defining presets
10.3.5

Example 3: Setting a preset on a circle center

The following probing steps are necessary in order to set the preset on a circle
center of the workpiece:
Probing
function
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
steps
Probe the hole at four points
Probe the edge in the Z– direction
The product defines the preset
centered in the hold of workpiece
Figure
10
177