Overview; Figure 30: Example Workpiece - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

9
9.1

Overview

This chapter describes the production of an example workpiece. As you produce
the example workpiece, this chapter leads you step by step through the product's
operating modes based on various machining scenarios. The following machining
steps are necessary for successful machining of the flange:
Machining step
Determine preset 0
Machine a through hole
Machine a rectangular pocket
Machine a fit
Determine preset 1
Machine a bolt hole circle
Machine a row of holes

Figure 30: Example workpiece

152
This chapter does not describe the processing of the outside contour
of the example workpiece. It is assumed that the outside contour has
already been machined.
For a detailed description of the individual activities, please refer to the
chapters "Manual operation", "MDI mode", "Programming " and "Program
run ".
Make sure that you have read and understood the "Basic operation"
chapter before carrying out the actions described below.
Further information: "Basic operation", Page 57
Mode of operation
Manual operation
Manual operation
MDI mode
MDI mode
Manual operation
Programming and program run
Programming and program run
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Quick Start | Overview