Display - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

15
15.2.3

Display

Path:
Parameter
Position display
Position values
Distance-to-go indicator
230
Settings ► General ► Display
Explanation
Configuration of the position display in the MDI mode and
Program Run operating mode. The configuration also deter-
mines the actions requested by the wizard in the MDI mode and
Program Run operating mode:
Position with distance to go: The wizard prompts you to
move the axis to the displayed position.
Distance to go with position: The wizard prompts you to
move the axis to 0, and a positioning aid is shown.
Settings:
Position: The position is displayed in large digits
Position with distance to go: The position is displayed in
large digits, and the distance to go in small digits
Distance to go with position: The distance to go is displayed
in large digits, and the position in small digits
Default setting: Distance to go with position
The position values can describe the actual values or nominal
values of the axes.
Settings:
Actual value
Nominal value
Default setting: Actual value
Display of the distance-to-go indicator in MDI mode
Settings: ON or OFF
Default value: ON
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Settings | General