Example 4: Setting A Preset In The Middle Of The Workpiece - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

10
10.3.6

Example 4: Setting a preset in the middle of the workpiece

The following probing steps are required in order to set the preset in the middle of
the workpiece:
Probing
function
178
steps
Probe the edges in Y+ direction and
the Y– direction
Probe the edges in the X+ direction
and X– direction
Probe the edge in the Z– direction
The product defines the preset in the
middle of the workpiece
Manual operation | Defining presets
Figure
1
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
2
M
1
2
M