Selection Of Rfid Tag Position Adjustment; Selection Of Rfid Offset Printing; Selection Of Label Shift Adjustment - Oki LE850 Technical Reference

5.22 SELECTION OF RFID TAG POSITION ADJUSTMENT

FEED
RESTART
Select a number from 0 through 9 for an applicable digit by pressing the [FEED] or [RESTART] keys.
Pressing the [PAUSE] key determines the value for the selected digit, then the cursor moves to the next
digit. (After setting a value for the last digit, the RFID tag position adjustment takes effect and the next
parameter is shown.)
This parameter specifies a fine adjustment value for the RFID tag position for RFID tag read/write.
NOTE: This parameter is used as the value for the feed amount of the TPCL @003 command at the
time of RFID read/write.

5.23 SELECTION OF RFID OFFSET PRINTING

FEED
RESTART
This parameter specifies a printer operation for the offset printing of RFID labels.
NOTE: This parameter is used for offset printing selection of the TPCL @003 command at the time of
RFID read/write.

5.24 SELECTION OF LABEL SHIFT ADJUSTMENT

FEED
RESTART
Select a number from 0 through 9 for an applicable digit by pressing the [FEED] or [RESTART] keys.
Pressing the [PAUSE] key determines the value for the selected digit, then the cursor moves to the next
digit. (After setting a value for the last digit, the label shift adjustment takes effect and the next
parameter is shown.)
Among the Zebra commands, the ^LS command shifts label position. If the ^LS command is not sent
to the printer, RFID labels are shifted based on this setting.
0
+ 1 -999.9 to +999.9 mm
- 8
9
NONE
•
WITHOUT BACKFEED
•
WITH BACKFEED
•
0
+ 1 -999.9 to +999.9 mm
- 8
9
- 25 -