Table of Contents
Advertisement
8.29 ^CW FONT IDENTIFIER
Format: ^CWa,d:o.x
a = Font number
A to Z, 0 to 9
When omitted: This command is ignored.
d = Drive
R : RAM
E : On-board Flash ROM
B : USB memory
A : USB memory
When omitted: R
o = File name
When omitted: UNKNOWN
x = Extension
When omitted: FNT
*1
For restrictions on the font name, refer to 8.2.
Note that, when a built-in font (Drive Z "Z:") is selected, the font is used and the parameter is not
applied as described above.
*2
In the Z-MODE, the font setting information generated by the default setting file is internally held
and ^CW command works by rewriting the font setting information using the font name as the key.
*3
The font names that can be referred to are limited to those included in "Font Change Table" of the
default setting file and up to seven downloaded TTFs.
The information contained in "Font Conversion Table," which is for ^A/^A@, cannot be used here.
*4
If the set value does not correspond to the information contained in the default setting file, this
command is ignored.
- 62 -
Advertisement
Table of Contents
