A@ Use Font Name To Call Font - Oki LE850 Technical Reference

Z-mode manual
Hide thumbs Also See for LE850:
Table of Contents

Advertisement

*8
While Font 0 is scalable, as the loaded fonts are different from those for Zebra, the font, size, space
between characters, etc. may differ.
*9
In the case of Zebra, the font selected in ^CF command is used when the name of nonexistent font
is selected. However, in the case of Oki Data, the font to be used follows the font conversion table
in ZDEFAULT.TXT.
*10 When OKI outline font is selected, the print image of character data using ^SN, ^SF, ^FV, or ^FC
command collapses from the second page on.

8.2 ^A@ USE FONT NAME TO CALL FONT

Format: ^A@o,h,w,d:o.x
o = Font rotation
N : 0°
R : 90°
I
: 180°
B : 270°
When omitted: Value of ^FW
* The point of origin differs depending on the coordinate designated in ^FT and ^FO.
h = Character height (in dots)
Font 0:
10 to 32000 dots
* Through correction, the final size shall be in the range from 1 mm to 150 mm.
Other than font 0:
If the character height exceeds 9.5 times the font standard height, it is corrected to 9.5 times.
When omitted: Calculated from the width based on the ratio.
w = Character width (in dots)
Font 0:
10 to 32000 dots
* Through correction, the final size shall be in the range from 1 mm to 150 mm.
Other than font 0:
If the character width exceeds 9.5 times the font standard width, it is corrected to 9.5 times.
When omitted: Calculated from the height based on the ratio.
d = Drive
R: RAM
E: On-board Flash ROM
B: USB memory
A: USB memory
When omitted: R:
o = File name
When omitted: UNKNOWN
x = Extension
When omitted: FNT
*1
When Font 0 is selected, the print image collapses if there exists other print data in the printing
area.
*2
The referable font names ("d:o.x") are limited to those in the "Font Conversion Table" or those in
the max. of seven downloaded TTFs.
A font name is valid only when all of the drive, file name, and extension are perfectly
If both height and width are omitted, the height is calculated from the value in ^CF.
If both height and width are omitted, the width is calculated from the value in ^CF.
- 34 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Le840

Table of Contents