Table of Contents
Advertisement
*3
When 180° is set for the coordinate specified in FT command and the X-coordinate of print start
position is set to a value which does not allow the entire bar code to be printed, the entire bar code
cannot be printed as printing is performed according to the set coordinate.
*4
When 0° /270° is set for the coordinate specified in FT command and the Y-coordinate of print start
position is set to a value which does not allow the entire bar code to be printed, the entire bar code
cannot be printed as printing is performed according to the set coordinate.
*5
If data outside of the effective range is entered, an unreadable bar code is printed with Zebra while
no bar code is printed with Oki Data.
*6
If the command is sent without setting data (only ^FS and ^XZ are set while ^FD^FS and ^FD are
not set), the barcode will not be printed.
*7
When the number of data digits for GS1 DataBar family (or the number of data digits before the
composite component in the case of the GS1 DataBar with the composite component) exceeds the
following, the printer does not print a bar code symbol.
"7: UPC-A":
"8: UPC-E":
"9: EAN-13:
"10: EAN-8:
"11: UCC/EAN-128 and CC-A/B": 48 digits
"12: UCC/EAN-128 and CC-C":
12 digits
10 digits
12 digits"
7 digits"
48 digits
- 51 -
Advertisement
Table of Contents
