Table of Contents
Advertisement
8.82 ^JU CONFIGURATION UPDATE
Format：^JUa
a = Configuration
F : The system mode is restored to default and the printer is reset.
N : The network setting is restored to default (unsupported).
R : The operation conditions are restored to the ones saved in the system mode.
S : The current operation conditions are reflected to the system mode and saved.
When omitted: This command is ignored.
* If "N: The network setting is restored to default" is selected, this command is ignored.
*1
When the parameter a is set to "R: The operation conditions are restored to the ones saved in the
system mode" and the tilde (~), caret (^), and delimiter (,) symbols differ from the current operation
conditions, reset the printer to synchronize it with BASIC application.
*2
When the parameter a is set to "F: The system mode is restored to default and the printer is reset,"
the default value is the initial value of the system mode setting.
*3
The system mode setting items and the default values for them are shown below.
LABLE LENGTH
LABEL WIDTH
RIBBON
PRINT MODE
SENSOR
PRINT SPEED
MAXIMUM LENGTH
POWER ON CALIB
HEAD CLOSE CALIB
DOT/MM
FORMAT CONVERT
CONTROL PREFIX
FORMAT PREFIX
DELIMITER CHAR
LABEL SIZE(LL)
LABEL TYPE(MN)
MEDIA TYPE(MT)
TONE ADJ(SD)
TONE ADJ(MD)
GRAPHIC POSITION
TAB -> SP
RFID ADJUST
OFFSET PRINT
LABEL SHIFT
0105.0mm:
104.0mm:
WITTH RIBBON: LE840T, LE850T
WITHOUT RIBBON: LE840D
NO CUT
TRANS
3 ips
0500.0mm
CALIBRATE
CALIBRATE
8dots/mm: LE840
12dots/mm: LE850
NONE
7E
5E
2C
ENABLE
ENABLE
ENABLE: LE840T/LE850T
DISABLE: LE840D
ENABLE
ENABLE
SPEED-ORIENTED
04
+000.0mm
NONE
+000.0mm
- 121 -
Advertisement
Table of Contents
