Table of Contents
Advertisement
8.16 ^BM MSI BAR CODE
Format: ^BMo,e,h,f,g,i
o = Font rotation
N : 0°
R : 90°
I
: 180°
B : 270°
When omitted: Value of ^FW
* The point of origin differs depending on the coordinate designated in ^FT and ^FO.
e = Check digit selection
N : No check digits
B : 1 Mod 10
C : 2 Mod 10
D : 1 Mod 10 and 1 Mod 11
When omitted: B
h = Bar code height (in dots)
203-dpi printer: LE840
1 to 800 dots
300-dpi printer: LE850
1 to 1200 dots
When omitted: Value of ^BY
*1 If the value after dot-to-mm conversion exceeds 100 mm, it is corrected to 100 mm.
*2 If 0, a string, or other value is selected, it is corrected to 10 dots.
f = Print interpretation line
Y : Printed
N : Not printed
When omitted: Y
g = Print interpretation line above code
Y : Printed
N : Not printed
When omitted: N
i = Print check digit
Y : Printed
N : Not printed
When omitted: N
*1
Data other than numeric values, if any, will be deleted.
*2
When data are set with ^SN and the parameter z of ^SN (add leading zeros) is N, '0' at the
beginning of data will be deleted.
*3
The character type of the interpretation line is independent of the module width value of ^BY. Font
A is used in any case.
*4
To print the interpretation line above code, the interpretation line parameter (parameter f) needs to
be set to "Y."
*5
If the command is sent without setting data (only ^FS and ^XZ are set while ^FD^FS and ^FD are
not set), the barcode will not be printed.
- 48 -
Advertisement
Table of Contents
