Table of Contents
Advertisement
8.17 ^BQ QR CODE BAR CODE
Format: ^BQa,b,c,d,e
a = Field position
N : 0° (fixed)
* The base point of printing differs depending on the coordinate designated in ^FT and ^FO and the
field position..
b = Model
1 : original
2 : Enhanced-recommend
When omitted: 2
c = Magnification factor
1 to 10
When omitted:
203-dpi printer: LE840
2
300-dpi printer: LE850
3
d = Error correction level (unsupported)
* When specified, the print result may differ from that with Zebra.
e = Mode selection for data portion
* When specified, the print result may differ from that with Zebra.
*1
While a space is placed between the point of origin and the print start point with Zebra in some
cases, printing with Oki Data starts from the point or origin regardless of the Zebra operation.
*2
Information about the error correction level and the data input is required for the data portion.
If information is insufficient, the print result differs from that with Zebra.
(The data effective area differs by 1 byte.)
*3
If an character outside the specified range is entered for the character mode of the data portion, a
command error occurs.
*4
After byte specification for the character mode of the data portion, if the data size is larger than the
specified number of bytes, the actual data size is effective for printing.
*5
If an lower-case alphabet is entered for the character mode of the data portion, a command error
occurs.
*6
Only when the error correction level and the input mode are the following parameters outside of the
effective range, the operation is the same as that with Zebra:
•
The setting characters for the error correction level and the input mode are lower-case
alphabets.
•
The setting characters for the error correction level and the input mode are alphabets outside
of the effective range.
•
Either of the setting characters for the error correction level and the input mode is not set.
*7
When only the error correction level and the input mode are specified for the data portion (e.g.
^FDQN^FS), the bar code data is [4Dh][4Dh][47h][52h] ("MMGR" in ASCII).
*8
If the command is sent without setting data (only ^FS and ^XZ are set while ^FD^FS and ^FD are
not set), the barcode will not be printed.
- 49 -
Advertisement
Table of Contents
