Ct Or ~Ct Change Tilde - Oki LE850 Technical Reference

8.28 ^CT OR ~CT CHANGE TILDE

Format: ^CTa or ~CTa
Change control command '~' (0x7E)
a = Control command character
Any character code from 0x20 to 0x7F
Non-omissible
Default: "CONTROL PREFIX" in the Z-MODE parameter
* The supported character codes differ from those for Zebra.
*1 When a job is cancelled while parameters are not saved by the JU command, the parameters
specified by this command will not be taken over after the job is cancelled but "reset."
- 61 -