Aligning The Paper Sensor; Checking The Position Of Paper Sensor - Oki PRO330S Manual

Aligning the paper sensor

Checking the position of paper sensor

The position of the paper sensor varies with the paper to be used.
Refer to the table below to check the set position and adjust the paper sensor accordingly.
• If the cut type setting of the machine do not match the position of the sensor, a paper jam will be falsely detected.
In that case, check the type of the paper loaded in the machine on the operator panel, and adjust the position of
the sensor accordingly.
To load paper with a black mark .................. Change the positions of the upper sensor and the lower sensor so
To load paper with a hole ............................ Change the positions of the upper sensor and the lower sensor so
• If you start the machine after changing the sensor position, the error 380 "PAPER JAM" may occur. Reset the
sensor by the following procedure.
1. Turn off the power if the machine is running.
2. Press and hold «OK» on the operator panel to power on the machine. Press and hold «OK» until [BOOT
MENU] appears on the display.
3. When [BOOT MENU] appears, release your finger and press «OK» again.
4. Input the password when the password entry screen appears. The password is the same as the one required
to enter [ADMIN SETUP].
5. Press « ∨ » several times to display [SENSOR RESET], and press «OK» to execute.
Media type
Paper with a Upper: Position of the black
black mark on
the printing Lower: Position where it does
side
Paper with a Upper: Position where it does
black mark on
the back
Lower: Position of the black
that they do not overlap.
that they do not overlap.
Sensor position
mark
not overlap with the
black mark on the front
not overlap with the
black mark on the back
mark
Settings from the printer driver or
operator panel*
Paper form
CONTINUOUS
PAPER
CONTINUOUS
PAPER
- 68 -
Cut type Gap length
B/M (FRONT) -
B/M (BACK) -