Br Gs1 Databar Bar Code - Oki LE850 Technical Reference

8.18 ^BR GS1 DATABAR BAR CODE

Format: ^BRa,b,c,d,e,f
o = Font rotation
N : 0°
R : 90°
I : 180°
B : 270°
When omitted: Value of ^FW
* The point of origin differs depending on the coordinate designated in ^FT and ^FO.
b = GS1 DataBar-14 family
1 to 12
1 : GS1 DataBar 14
2 : GS1 DataBar 14 Truncated
3 : GS1 DataBar 14 Stacked
4 : GS1 DataBar 14 Stacked Omnidirectional
5 : GS1 DataBar Limited
6 : GS1 DataBar Expanded
7 : UPC-A
8 : UPC-E
9 : EAN-13
10 : EAN-8
11 : UCC/EAN-128 and CC-A/B
12 : UCC/EAN-128 and CC-C
When omitted: 1
*1 When the GS1 DataBar family notified by this command is "6: GS1 DataBar Expanded" and the
number of segments is an even number other than 22, the GS1 DataBar family notified to TPCL
shall be "6: GS1 DataBar Expanded Stacked."
c = Magnification factor
1 to 10
When omitted: 2
d = Separator height (unsupported)
1, 2
* Operation is performed with the fixed value 1.
e = Bar code height (in dots)
1 to 32000 dots
When omitted: 25 dots
* This parameter is valid only when the GS1 DataBar family is set to "11: UCC/EAN-128 and CC-
A/B" or "12: UCC/EAN-128 and CC-C" and set to the value obtained after "c = Magnification
factor" is applied. If the calculation result exceeds 100.0 mm, it is corrected to 100.0 mm.
f = Segment width
2 to 22
When omitted: 22
*1 When the bar code is rotated at /90° /180° /270° on the coordinate specified in FO command, the
bar code is not printed at the specified position.
*2 When the bar code is rotated at 0° /90° /180° /270° on the coordinate specified in FT command, the
bar code is not printed at the specified position.
- 50 -