Table of Contents
Advertisement
*4
If a back slash code (0x5c) is placed in the data to be printed (command "^FD"), line feed is made.
To actually print the back slash code, it needs to be sent continuously.
*5
If the text block/line width is set to a value insufficient to print two characters (a value that allows
only one character to be printed in a line) and the maximum number of lines in text block is set to a
value which is insufficient for the print data length (e.g. only four lines are secured for ten-character
data to be printed in ten lines), overwrite drawing in the final line is not made. Otherwise, the data
portion exceeding the set value is overprinted in the final line.
*6
When the used font is Oki Data's external character (01 to 40, 51 to 55), Japanese Kanji character
(U, V, W, X, v, w), or Chinese character, the parameters d (text justification) and e (indent) are
ignored. If the number of characters exceeding the text block/line width is entered, the field is not
printed.
*7
Since the paper width is not checked for the text block/line width and the indent width settings, they
shall be set to a value which does not exceed the paper width.
*8
If the head of the data to be printed is a space code, the space codes between the top and the first
character are discarded when reading. However, if the space codes to be discarded exceed the
text block/line width, the space codes equivalent to the line width are converted to a line feed code.
*9
Special code (code after back slash)
If the special code is 0x30 or smaller, the operation differs from that with Zebra.
•
Codes handled as terminator in the Z-MODE
0x00 terminates data processing.
0x0a is converted to 0x00 and terminates data processing. The latter data are discarded
when reading.
0x0c is converted to 0x00 and terminates data processing. The latter data are discarded
when reading.
0x0d is converted to 0x00 and terminates data processing. The latter data are discarded
when reading.
•
Codes discarded in the Z-CODE
0x01 to 0x08, 0x0b, and 0x0e to 0x12
•
Codes converted in the Z-MODE
0x5c is converted with 0x1f CI information (only in the case of CI13)
0x30 is converted with 0x1a CI information (only in the case of CI13)
0x09 is converted to 0x20 as many times as specified in the tab space conversion in the
downloaded default setting file in the system mode.
•
The operation for special code (0x20) differs from that with Zebra.
With Oki Data, it is converted to a line feed code.
•
The operation for special code (0x23, 0x28) differs from that with Zebra.
With Oki Data, a line feed is made and the code is printed at the beginning of the next line.
•
With the special code 0x1f, which develops into 0x1f+0x1f, a back lash is printed.
- 72 -
Advertisement
Table of Contents
