Starting And Stopping The Engine - Mitsubishi LANCER Owner's Manual

Features and controls
To lock
Remove the key at the "LOCK" position.
Turn the steering wheel until it is locked.
To unlock
Turn the key to the "ACC" position while moving the steering
wheel slightly.
CAUTION
!
Remove the key when leaving the vehicle.
NOTE
3
If the front wheels are turned, the anti-theft lock may
sometimes make it difficult to turn the key from "LOCK"
position to "ACC" position. Firmly turn the steering
wheel to the left or to the right as you turn the key.
3-88

Starting and stopping the engine

Tips for starting
Do not operate the starter motor continuously for longer
than 15 seconds as this could run the battery down or
damage the starter motor. If the engine does not start, turn
the ignition switch back to the "LOCK" position, wait a
few seconds, and then try again. Trying repeatedly with
the engine or starter motor still turning will damage the
starter mechanism.
If the engine will not start because the battery is weak or
discharged, refer to "Jump-starting the engine" (on page
6-2) for instructions.
[Except for vehicles equipped with the turbocharger]
The engine is warmed up enough for driving when the bar
graph of engine coolant temperature display starts to
move. A longer warm up period will only consume extra
fuel.
[For vehicles equipped with the turbocharger]
The engine is warmed up enough for driving when the bar
graph of engine coolant temperature display starts to
move. Driving before the bar graph moves may cause
deterioration of turbocharger performance and driveabil-
ity. A longer warm up period will only consume extra
fuel.
On vehicles equipped with the Twin Clutch SST, the fol-
lowing may occur after the engine is started, but they do
not indicate an abnormality.
• You may hear operational sounds of the Twin Clutch
SST and you may feel vibration in the vehicle body.
N00542100060