Mark On Horizontal Cone - Panasonic LP-M Series Operation Manual

1-4-5 Mark on Horizontal Cone

„ Sample
Bottom-base
Diameter of
Cone: 20 mm
Marking Image
Original Point of World
Coordinate
Original Point of Local
Coordinate
-10mm
„ Setting Flow
1. Set the cone (laid-down).
Set the size, angle, and center position of the cone.
2. Set the marking condition.
Set the character type and character position to be marked on the cone (horizontal).
Top-base
Diameter of
Cone: 10 mm
Length of
Cone: 20 mm
Z
-16mm
Center of 3D Figure
Marking Figure
ME-LPMSZ-OP-7
[Setting of figure]
• Layer No.
• Work Type
• Top-base Diameter
• Bottom-base Diameter
• Length of Cone
• Center Position X
• Center Position Y
• Center Position Z
[Character Condition]
• Marking content
• Starting Coordinate X
• Starting Coordinate Y
• Character Height
• Character Width
• Character Interval
Original Point of
Local Coordinate
-8mm
X Position, Y Position
(Character Condition)
Marking Character
: 0
: Hori. Cone Convex
: 10 mm
: 20 mm
: 20 mm
: -10 mm
: -16 mm
: -8 mm
: ABCD
: -8 mm
: -2 mm
: 4 mm
: 3 mm
: 4 mm
Y
-2mm
-8mm
X
67