3. Set the marking layout
Set the size and coordinate for the marking contents. Here describes the procedures to set the following layout.
Character Height 4 mm
Starting Coordinate
X : -10 mm
Y : 5 mm
1.
Press [CONDITION].
Then, press [CHARACTER].
2.
Set "4 mm" to [Character Height].
Set "4 mm" to [Character Width].
Set "-10 mm" to [X Position].
Set "5 mm" to [Y Position].
Set "5 mm" to [Char. Interval] (Character Interval).
3.
Press [IMAGE] to check the marking layout.
Character Interval 5 mm
ABCD
Character Width 4 mm
ME-LPMSZ-OP-7
19