Panasonic LP-M Series Operation Manual page 234

„ Ethernet
This screen specifies the Ethernet communication setting. Set this to perform Ethernet communication.
Select the [Ethernet] and press [Change] button to show the Network Setting Screen.
Press [OK] to save the settings. (Press [Cancel] to discard the changes.)
Environment 3 Screen
Item
1 IP Address
2 Subnet Mask
3 Default
Gateway
4 Port
5 MAC Address
Notice
• The communication control of the laser marker through the Ethernet should be performed in a secure network
environment.
Reference
• "Octet" is a 3-figure value delimited by dots. From the beginning, it is called the "1st octet", "2nd octet", and so forth.
• Depending on the combination, there are cases where IP Address and Subnet Mask values cannot be set even if they
are within the setting range.
• Make sure that the IP address for the laser marker on the network is not overlapping the IP address for the PC.
• When the backup data is restored to the laser marker, communication parameter settings are overwritten with the
backup data. After restoring, confirm the IP address and other parameters.
234
Description
: Sets the IP address.
Setting Range 1.0.0.0 to 223.255.255.255 (except 127 in the 1st octet)
Initial Value 192.168.1.5
: Sets the subnet mask.
Setting Range 128.0.0.0 to 255.255.255.254
Initial Value 255.255.255.0
: Sets the default gateway.
Setting Range 1.0.0.0 to 223.255.255.255(except 127 in the 1st octet)
Initial Value None (blank)
: Sets the port.
Setting Range 5001 to 65534 [except 9090 and 9091]
Initial Value 9094
: Displays currently set MAC Address.
1
2
3
4
5
Network Setting Screen
ME-LPMSZ-OP-7