Functional Description - Panasonic LP-M Series Operation Manual

2-2 Functional Description

Functions
3D Marking *3
Marking order optimizing
Intersection offset
Counter marking
Current date marking
Expiry date marking
Lot marking
Time hold input
Logo data marking
Barcode marking
Processing Performance
function
Arbitrary Point Irradiation
Function
Flying Object marking
function
Step & Repeat
Over-marking
Rank marking
External offset
Serial data marking
Bold character marking
Marking shape setting
Font selection
Marking image display
80
Outline
The 3D marking function can set max.16 types per one file.
Applicable 3D shapes:
- Plane (slope/uneven)
- Cylinder (convex/concave)
- Horizontal Cone (convex/concave)
- Vertical Cone (convex/concave)
- Sphere (convex/concave)
* Marking to flying object with 3D setting cannot be performed without using the encoder.
* When performing marking to flying object with 3D setting, marking time cannot be
measured regardless of using or not using the encoder.
This allows rearranging of marking order of characters to shorten the time required for
marking.
This keeps the intersection points of characters from being engraved too deeply.
The marking is performed sequentially according to the counter conditions you set.
(Count-up/Count-down)
This allows marking of current date or time.
This allows marking of date or time calculated by adding the specified period/time to the
current date or hour.
This allows marking by replacing the current (expiry) date, time, and counter value with
specified character string for marking.
The time hold signal equipped in I/O connector keeps the time and date at the timing of its
ON input.
By following the holding time, the functions based on the clock, such as current date,
expiry date, lot and counter reset at updating operate.
This allows marking of the drawing data in DXF/HPGL/BMP/JPEG/AI/EPS form. (DXF
format data may be directly imported into the laser marker. Other data needs to be
converted using the attached software in advance.)
Marking of various bar codes, 2D codes and composite codes is possible. Inputting
character data will automatically generate a bar code.
Specify the coordinates for "Straight Line", "Circle", or "Arc", and radiate the laser.
Specify the coordinates for "Point" and exposure time, and radiate the laser.
Marking following the moving target object is possible according to the specified line
speed and encoder signal.
This allows marking of character string in matrix state by specifying the numbers of Row/
Column and the Intervals.
Overwriting marking is done according to the specified overwriting frequency and interval.
A number of character strings are registered in the data table, and marking is done by
switching with the I/O signals.
A number of marking coordinates are registered in the data table, and marking is done by
switching with the I/O signals.
Marking is performed, changing the marking character string using communication
command.
Mark a character string in bold.
This allows for selection of marking shapes: "Straight Line", "Proportional", "Justify", "Arc
outside (+)" and "Arc inside (-)."
This allows for selection of registered fonts for marking character (alphanumeric). Fonts
can be newly created and edited with the attached software.
This allows displaying of characters or graphic to be marked on the image screen.
ME-LPMSZ-OP-7