Panasonic LP-M Series Operation Manual page 169

„ Pattern Setting for QR code and Data Matrix code
1
QR code
Specify the drawing pattern of the 2D code for the each code component.
Description
1 Pattern code:
Specify the drawing pattern of the 2D code for the each code
component.
Press the pattern code field and select the drawing pattern.
Press "Clear" to set "0" in the pattern code.
For setting a inverted (Black/White) code, set the pattern code
as follows;
• For QR code, select the drawing pattern to the light module.
Specify "0" to margin, finder, alignment and dark module.
• For Data Matrix code, select the drawing pattern to the
space module. Specify "0" to quiet zone, mark module and
border.
Reference
• For QR code, when the pattern code is set to "0" in finder or alignment, these patterns are marked using the settings
for dark or light module.
• For Data Matrix code, when the pattern code is set to "0" in border, these patterns are marked using the settings for
mark or space module.
• On the pattern code input screen, the pattern image registered into 2D code font (2230 (HEX) to 2239 (HEX) and
8121 (HEX) to 8152 (HEX)) is displayed.
• The pattern code can be specified also by inputting the character code directly in the pattern code field.
2 Laser Power Correction :
Scan Speed Correction :
Laser Pulse Cycle Correction (Except LP-SxxxW type) :
Correction of each code pattern for the laser power / scan speed / laser pulse cycle set at laser setting.
Setting Range of Laser Power Correction
Setting Range of Scan Speed Correction
Setting Range of Laser Pulse Cycle Correction
Reference
• If the value of "Laser power correction" × "laser power" is equal to or larger than 100, the setting will be "100".
• Marking is not available when the laser power correction value is "0".
• If the corrected value exceeds the setting limit, the nearest upper or lower limit value of the each item is set.
2
0 to 999%
1 to 999%
1 to 999%
ME-LPMSZ-OP-7
3
Data Matrix
169