Laser Output Confirmation - Panasonic LP-M Series Operation Manual

2-16-4 Laser Output Confirmation

1
3
LP-M5xx / LP-M2xx / LP-Sxxx type
1
LP-SxxxW type
Item
1 Low Power Detect
(LP-M5xx / LP-
M2xx / LP-Sxxx
type only)
2 Measure/Correct
(LP-M5xx / LP-
M2xx / LP-Sxxx
type only)
3 Show Energy
Measurement
(LP-M series / LP-
Sxxx type only)
4 Power Check
(LP-Z series / LP-
SxxxW type only)
236
2
4
Description
: Set the decay percentage relative to the initial output of the laser oscillator.
If the measurement falls below the preset limit during the laser power measurement, an
error message appears.
Refer to "Laser output measurement/correction" (P.241) for details.
: The current power of the laser marker against the output of the laser marker at shipping
is possible to be checked. After the measurement if the power decays lower than the
delivery status, the laser power setting value can be corrected.
Refer to "Laser output measurement/correction" (P.241) for details.
: When enabling this function, the marking energy and period are displayed after the test
marking is finished. Refer to "2-11-2 Marking Energy Measurement" (P.187) for the marking
energy.
: The current power of the laser marker against the output of the laser marker at shipping
is possible to be checked. After the power check if the power decays lower than the
delivery status, the laser power setting value can be corrected.
Refer to "Power check" (P.244) for the detail.
ME-LPMSZ-OP-7
3
LP-MAxx type
4
LP-Z series