Setup And Connect The Laser Marker - Panasonic LP-M Series Operation Manual

1-2-1 Setup and connect the laser marker

Reference
• For the installation and connecting, refer to "Safety / Setup / Maintenance Guide".
1.
Install the laser marker ensuring the following points.
• Take laser protection measures required to use Class 4 laser products.
• Please avoid vibration and install in a place without any shocks.
• For the proper cooling performance, install not to bar the flow of air.
2.
Connect the head and controller of the laser marker using these cables.
• Head control cable
• Head power cable
• Laser gate cable *1
• Fiber cable *2
3.
Connect the following devices and cables to the controller.
• Touch panel console and return harness, or monitor and mouse, or PC
• Input / output terminal *3
• Interlock connector *3
• Laser gate terminal *1, *3
• Input connector for displacement sensor *4
4.
Connect the controller power cable.
*1 : Only for LP-Mxxx-S type.
*2 : For LP-M and LP-Z series, the fiber cable cannot be detached from the device.
*3 : Wire the each terminals depending on the control method.
*4 : Only for LP-M series.
*Place a protective enclosure in the range of laser radiation for actual use.
ME-LPMSZ-OP-7
15