Panasonic LP-M Series Operation Manual page 250

„ Flow Chart
1. Installing/Removing the fiber unit
Install/Remove the fiber unit.
See "Safety / Setup / Maintenance Guide" for details.
2. Checking the shifting of the marking position
Mark "WORKAREA.VEC" that is preliminarily registered in the file No. 2045.
Before marking, set X, Y, and Rotation System Offset in the environment setting screen to "0".
For details on the setting of logo file, refer to "2-10-3 Logo Condition" (P.155).
3. Checking the guide laser
Leave the finished work as it is, and trace the marking on the work with the guide laser.
For the guide laser, refer to "2-6-2 Guide laser" (P.93).
Shifting of the marking position
is not observed
Reference
• The above procedure is to correct the marking position at the time of delivery.
• Perform the above procedure by setting the work at the center position of the work distance, and setting the "Work
Distance" in "Laser Setting" to the value of the center position of the work distance.
250
Shifting of the marking position is observed
4. Adjusting the marking position
In view of the gap between the actual marking and the guide
laser, set the Marking Position Calib. X/Y.
For details on the settings, refer to "2-16-5 Maintenance
(Environment 3)" (P.248).
5. Repeating the steps
Repeat the steps 2, 3 and 4 in this order to set the correct
marking position.
Completion
ME-LPMSZ-OP-7