Point Radiation Condition - Panasonic LP-M Series Operation Manual

2-10-6 Point Radiation Condition

Laser radiates in the specified coordinate for the setting time.
Reference
• Point radiation function can not be used in combination with the function of marking to flying object.
• For LP-M and LP-Z series, when the "3D" on the "2D/3D setting" of the common condition on for the general condition is
checked ON, the point radiation function becomes invalid.
1
2
5
11
Description
1 Point Rad. No. (Point Radiation No.) :
Specifies up to 16 point radiation condition per one registered file.
Setting Range
2 X/Y Offset :
Shifts the object to X/Y direction for all radiation points in the selected point radiation No.
Setting Range
3 Laser Power Correction :
Laser Pulse Cycle Correction (Except LP-SxxxW type) :
Correction of all radiation points in the selected condition No. for the laser power / laser pulse cycle set at laser
setting.
If the correction rate is set to 0%, the marking image is displayed in gray and marking is not executed.
Setting Range of Laser Power Correction
Setting Range of Laser Pulse Cycle Correction
4 Layer No. :
When more than one condition of the marking data is set, layer No. specifies the marking order. The laser marker
performs the marking with the smaller order of the layer No. specified beforehand (Layer No. 0 is firstly marked,
and Layer No. 15 is marked finally.). Note that it is not applicable for the Step & Repeat marking.
Setting Range
8 9
0 to 15
-60.000 to +60.000 mm (LP-M500 / LP-Z130)*
-45.000 to +45.000 mm (LP-S500)*
0 to 15
3
4
6
7
10
0 to 999%
1 to 999%
ME-LPMSZ-OP-7
181