Panasonic LP-M Series Operation Manual page 133

Description
7 Direction:
Specifies the marking order of the bar code and composite code marking.
• One Dir. (One way direction) : Marks the bar code and composite code marking from one way direction.
• Bidir. (Bidirection)
8 2D Code Skip Marking :
Specifies the marking order of the 2D code and composite code marking.
To reduce the heat effect by laser in the drawing modules of the code, valid this function.
Skip marking
1
1
3
2
Reference
• In case of marking to flying object, set the 2D code skip mark to "Invalid".
9 2D/3D Setting (LP-M / LP-Z series only) :
Check "3D" of the 2D/3D setting for marking to 3D figure work.
When checking "3D" of the 2D/3D setting, the layer condition can be set and marking setting for 3D figure work
becomes available. Refer to "Layer Condition" (P.134).
Reference
• "Step & Repeat", "External Offset", "Processing Condition", "Fixed Point Radiation Condition", "Concatenated Marking
Setting", and "Marking to Flying Object" (when encoder not used) can not be used in combination with 3D setting.
: Specifies the marking order of the bar code and composite code marking.
One way direction
1
2
1
3
2
4
ME-LPMSZ-OP-7
Bidirection
Non-skip marking
1
1
1 2 1
3
3
2
2
4
133